Dyno day at Speed Inc: +63 rwhp
Today I was off to the dyno. Apparently my MAF was flaking out, so had to have a new one put in mid-session. I made about what I expected with a gain of 63rwhp. It’s officially faster than a z06 now.
Today I was off to the dyno. Apparently my MAF was flaking out, so had to have a new one put in mid-session. I made about what I expected with a gain of 63rwhp. It’s officially faster than a z06 now.
First trackday of the year last night. Shaking the cobwebs off. No PBs, but set some respectable times. Followed a c8 z06 z07 for a while. Didn’t do too bad considering he had 250hp advantage. My autoblip didn’t like the MC change I made and wasn’t working. I think I need to make the switch…
Last weekend I was out at Blackhawk Farms again, this time with Northwoods shelby club. Two weekends in a row is a lot for me. However my folks came out from Idaho and I took them to the track with me. My dad got to ride on the track for the first time with me….
Exciting day. The quickjack arrived and got assembled. I’ve been waiting on it to get started with some of the mechanical work.
Last night was my first time trials event. I was at Autobahn North, which is normally the configuration reserved for members during the day. However this was an evening event, which was another first. Drivers’ meeting was 4:45 and first car off about 5:15. Only 3 sessions, but only 3 run groups as well so…
Finished up chasing down the ABS codes today I installed the brake switch from above and it works perfectly. It’s also wired exactly like BMW originally did now instead of through a complicated mess. When I did the original setup I thought it was odd that INPA listed the brake as “on” when the pedal…
I got the engine pretty much assembled. Start out with that fresh block smell. Never seen it so clean. Then I laid in the crank. Plastigauge says I have around 0.0018″ clearance. Next up was gapping some rings. I went 0.022″ top and 0.024″ bottom. Maybe a little loose for NA, but better to be…