Hydraulic lines finished + routing
Finished up the hydraulic lines

also a better pic of routing near the steering shaft

Finished up the hydraulic lines

also a better pic of routing near the steering shaft

Never fixed a rack but they’re not difficult to remove. You might want to upgrade the rack mounting bushing while you’re in there, it’s cheap and easy. https://www.dougrippie.com/drm-steering-rack-bushings — nsogiba, Grassroots Motorsports forum, March 6, 2024 In reply to nsogiba : I hear it’s just a lot of work. I need to disassemble the front…
Current snapshot- not including mostly maintenance stuff like seals, wires, non performance stuff, etc. Engine/power train- 363rwhp KN style filter with stock box top removed Hooker shorty headers SDPC ls6 powermax plus cam Borla axleback Melling HP high flow pump Ls6 beehive springs Michigan motorsports trunions Oil catch can powerbond SFI 10% ud pulley T1 steering…
Yesterday I put my wang on. Install wasn’t too bad. Pop off the bumper Measure the wing mount distance Put the uprights on the car and mark triple check Notch the tub triple check drill the mount holes mount the uprights lay out tape on the rear deck Use a square to transfer the upright…
Installed an auto-blip tonight. Pretty easy to do. Tap into power at the OBD, Clutch top switch, brake light switch, and then 3 throttle wires. When the brake and clutch are depressed at the same time it’ll blip. Duration and delay are adjustable with the little control box below.
Back to Autobahn today. Today was really frustrating. Session 1 was great. Ran a 1:37.50, but I forgot to put a memory card in my camera. :\ I was running in advanced group and very little interaction with traffic. Session 2 my car was badly misfiring. I went back to the paddock after 2 laps….
Windy City BMW event 5 today. Timing was down in the morning so we did fun runs. In the afternoon they decided to manually time cars so that we could have a scored event. Only 4 runs to get it down. 2nd in class again. 3rd overall on raw time.